Microsens RS232 Especificaciones descargar pdf (Pagina 39)

19'' 6U Chassis page 39/71

T:\home\> tftp -i 192.168.16.123 PUT xxx.ext /tftpboot/yyy.ext

Where: T:\home – is the location of the code on your PC

xxx.ext - is the name of the code you wish to upload and

yyy.ext - is the new name of the code you wish to upload

When renaming the code ensure that the new name is compliant with the Unix

standard and no more that 24 characters long including the extension.

192.168.16.123 - is the IP address of the MS430502M chassis into which

the file is to be loaded.

Return of the prompt indicates completion of download.

• Perform a set on the object:

mgnt2LoadMSTableUpdate

Location:...\microsens\mgnt2\mgnt2SoftwareManagement to refresh the

contents of the RAM.

• Verify the presence of the new code in the RAM, by reading the table:

mgnt2LoadMSTable

Location: ...\microsens\mgnt2\mgnt2SoftwareManagement.

• Ensure the file extensions correspond to the expected result:

*.srec => Software

*.hexout => Gateware

In the event of an incorrect completion of this phase see Fall Back 4 for reverse

procedure. (Fall Back Procedures)

2. Transfer Phase

The object of this phase is to transfer the code previously loaded into the MGNT to the

generic slot MS. There are no service implications during this phase.

Stage 1 – Preparation

• Ensure that the correct module is selected for management. Consult the

object:

mgnt2GigmSelectedBoard

Location:

...\microsens\mgnt2\mgnt2SNMPAgentData\mgnt2ModulesManagement\

• Change if necessary

• Depending on upgrade; check the Software or Gateware bank occupancy in

the selected module by consulting the objects:

• Software:

msXXXXXXXDwlSwBank1Notempty

msXXXXXXXDwlSwBank2Notempty

Location:

...\microsens\moduleMsXXXXXXX\msXXXXXXXdownload\msXXXXXXXDwlOther

MICROSENS GmbH & Co. KG - Küferstraße 16 - 59067 Hamm - Tel. +49 2381/9452 0 - Fax 9452 100 - www.microsens.com

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 70 71

Sin comentarios

Microsens RS232 Especificaciones Pagina 39