Microsens RS232 Especificaciones descargar pdf (Pagina 29)

19'' 6U Chassis page 29/71

file must be cleared to insure correct log

function

mgnt2AlmLog80Full

Log File Full Warning :

This OID indicates that a log file is 80% full.

Check the log files

Table :1 MGNT Alarms list

Traps

A trap is an unsolicited, asynchronous event that the MS430502M chassis generates to

indicate a status changes; e.g.: a trap is generated on the detection of a start of an

alarm and an end of an alarm. It is impo rtant to set the IP address of the manager

correctly in order to receive the traps.

The following table lists the possible traps originating from the MGNT Board:

MGNT Traps

Name

Description

Possible cause Action

mgnt2TrapApi

Api error trap with its number

See API Code Table

Reboot the agent (Warm

Reset)

mgnt2TrapSwError

MGNT software error other API

Fault in SNMP Agent write

operation, resulting in an

unsuccessful set operation

Reboot the agent (Warm

Reset)

mgnt2TrapHwError

MGNT hardware error

Fan failure (Fan number indicated

in the trap message)

Carry out relevant

maintenance

procedure

mgnt2TrapBoardInserted

MS module inserted

A MS module has been inserted No action, information only

mgnt2TrapBoardRemoved

MS module removed

A MS module has been removed No action, information only

mgnt2TrapRestoreConfDone

MS Configuration restored

The configuration of the MS

modulehas been restored with the

one stored in the MGNT

No action, information only

mgnt2TrapGlobalPowerFail

One power input is in fail condition

There is no power cable connected

on the power connector of the

MS430502M chassis

No action, information only

mgnt2TrapLogFileFull

One of the log file is full or 80% full

One of the log files is either full or

80% full

Check the log file and reset

them to insure the correct

working if this log function

Table :2 MGNT Traps list

API Codes

The following table lists the API codes that can accompany specific Alarms and Traps.

The information codes are not errors; the API indicates the state of communication

with the module as information.

MICROSENS GmbH & Co. KG - Küferstraße 16 - 59067 Hamm - Tel. +49 2381/9452 0 - Fax 9452 100 - www.microsens.com

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 70 71

Comentarios a estos manuales

Sin comentarios

Microsens RS232 Especificaciones Pagina 29

Comentarios a estos manuales