Microsens RS232 Especificaciones descargar pdf (Pagina 23)

19'' 6U Chassis page 23/71

• Automatic with DIP switches

The MS430502M chassis MGNT Management Board is equipped with 8 DIP

switches that may be used to define the MS430502M chassis IP Address. The

following picture gives the location of these DIP switches on the Board.

Figure 13: MGNT Board top view

The DIP switch can be used to set the last byte of the MS430502M chassis IP

Address. The right switch is the Most Signficant Byte of the byte and the left

switch is the Least Significant Byte of the byte. For each switch, the top position

represents a 1 and bottom position represents a 0.

In the previous picture, the DIP switches define a value of 108 (0x6C). The

automatic IP address configuration by DIP switch procedure is carried out in two

phases:

1. Define the IP Address map (the three first bytes of the IP address).

2. Configure the DIP switches to set the last byte of the IP address.

Described in more details as follows:

Procedure

1. Define the IP Address map

• Use the default MS430502M chassis IP address to get access to the SNMP

agent

• Set the object

mgnt2GigmBoardIpAddress

Location: ...\microsens\mgnt2\mgnt2SNMPAgentData\ mgnt2IPmanagment

MICROSENS GmbH & Co. KG - Küferstraße 16 - 59067 Hamm - Tel. +49 2381/9452 0 - Fax 9452 100 - www.microsens.com

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 70 71

Sin comentarios

Microsens RS232 Especificaciones Pagina 23