Microsens RS232 Especificaciones descargar pdf (Pagina 33)

19'' 6U Chassis page 33/71

And which one is currently being extracted by the variable:

mgnt2ExtractedPack

• Check the presence of the required package in RAM

Using your SNMP browser perform a table update and consult the

table: mgnt2DwlUploadingTable

If at this stage there are any problems with the package in RAM, name etc., it

can be erased by setting the value: mgnt2DeletePackageFromRam to “ON”. This

allows the selected package to be erased from the RAM without affecting the

other table values.

• Set to “on” the variable:

mgnt2FileUpload associated with the required package.

This validates the transfer of that package to FLASH.

Transfer begins as soon as this action is done. Copying to FLASH lasts

approximately twenty seconds. Do not attempt any manipulations on the

software manager during this time.

• Progress indicator:

The value: mgnt2FlashingInProgress is set to “on” during a file

transfer and returns to “off” on completion of the operation.

• Check that your package loaded correctly in the FLASH by consulting the

table:

mgnt2DwlPackageTable

After the transfer to FLASH, the selected package is erased from the RAM.

In the event of an incorrect completion of this phase see Fall

Back 2 for reverse procedure. (Fall Back Procedures)

3. Installation Phase

The object of this phase is to install the previously transferred software package, and

make it available to the system.

There are no service implications during this phase.

• Check the status of the FLASH:

Consult the dwlpackage table: mgnt2DwlPackageTable

This will display the packages resident in the FLASH:

(mgnt2DwlPackageFileName)

And which one is currently being extracted in the system

(mgnt2ExtractedPack)

• Enable the new package by setting to two its associated object:

mgnt2SwitchTo

This extracts the new binaries to the flash-ram, overwriting the previous

binaries.

This operation takes at least three minutes.

Do not turn off the machine during this time.

Do not Reset the MS430502M chassis during this time.

MICROSENS GmbH & Co. KG - Küferstraße 16 - 59067 Hamm - Tel. +49 2381/9452 0 - Fax 9452 100 - www.microsens.com

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 70 71

Sin comentarios

Microsens RS232 Especificaciones Pagina 33