Microsens RS232 Especificaciones descargar pdf (Pagina 25)

19'' 6U Chassis page 25/71

performed using a ping function. The estimated time to detect a dead gateway is less

than 30 seconds.

The table

• mgnt2GigmGatewayAddressTable

Location: ...\microsens\mgnt2\mgnt2SNMPAgentData\mgnt2IPmanagment

Contains the following objects

• mgnt2GigmGatewayAddress

• mgnt2GigmGatewayOrder

These two objects allow the user to define two different gateways and their order.

The MGNT board resets automatically in a warm manner to apply any modification in

the gateways configuration.

Setting the Manager IP addresses

The IP address of the manager must be set to enable trap reception. It is possible to set

several managers IP address. In that case, all the managers specified in the manager list

will receive all the traps sent by the MS430502M chassis To change the default IP

address of the manager or add a new address, the following object is concerned.

• mgnt2GigmManagerIpAddressTable

Location: ...\microsens\mgnt2\mgnt2SNMPAgentData\ mgnt2IPmanagment

This table references three objects:

• mgnt2GigmManagerIpIndex

• mgnt2GigmManagerIpAddress

• mgnt2GigmManagerIpAddressTableRowStatus

It is possible to modify, add, remove or disable an IP address.

It is mandatory to keep always at least one entry in this table.

The Manager IP address manipulation can be changed off site prior installation.

Setting the MS430502M chassis Name

The object:

• mgnt2GigmLogicalName

Location: ...\microsens\mgnt2\mgnt2SNMPAgentData, enables the user to assign a name

to each MS430502M chassis in the network,(Alpha – numeric up to 255 characters).This

name may be used in maintenance work, i.e. to assist in locating a MS430502Mchassis.

All alarms and traps originating from the MS430502M chassis areaccompanied by the IP

address of the system not the name.

Setting the SNMP Communities

The object:

• mgnt2GigmRoCommunity, defines the SNMP Get community

• mgnt2GigmRwCommunity, defines the SNMP Set community

MICROSENS GmbH & Co. KG - Küferstraße 16 - 59067 Hamm - Tel. +49 2381/9452 0 - Fax 9452 100 - www.microsens.com

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 70 71

Sin comentarios

Microsens RS232 Especificaciones Pagina 25