Microsens Media Converter/Signal Repeater Module Manual de usuario descargar pdf (Pagina 14)

Media Converter/Signal Repeater page 14/29

NAME DESCRIPTION ACTION

ms430580mAlmLine2Fail Line 2 Failure: This OID

indicates a failure on the Line 2

Correlate relevant alarms. Carry

out necessary maintenance

procedures.

ms430580mAlmLine2LasFail Line 2 SFP Tx Failed: This OID

indicates that the transmitter

fails for the transceiver plugged

into the Line 1 (this alarm

reports the transmitter failure

alarm generated by the

transceivers)

Correlate relevant alarms. If

Alarm

persists replace the Client SFP.

ms430580mAlmLine2Los Loss of Optical signal on Line 2:

This OID indicates that no

signal is present on the

transceiver 2

Check client status. Carry out

necessary maintenance

procedures.

Traps

A trap is an unsolicited, asynchronous event that the MGNT generates to indicate a

status change; e.g.: a trap is generated on the detection of a start of an alarm and an

end of an alarm.

Note

It is important to set the IP address of t he manager correctly in order to receive

the traps.

There are two types of trap:

• Line 1 traps originating from Line 1 problems.

• Line 2 traps originating from Line 2 problems.

These are further categorised as follows:

• Critical: –Traffic affecting, demanding immediate attention.

• Urgent: –Indicating that maintenance is required.

• Non-urgent: – Warning, information, non traffic affecting origin DDM.

The binding information that accompanies a trap is for information only and should be

used to make the alarm polling more efficient.

The following table lists the possible traps originating from a MS430580M and their

contributing alarms.

MICROSENS GmbH & Co. KG - Küferstraße 16 - 59067 Hamm - Tel. +49 2381/9452 0 - Fax 9452 100 - www.microsens.com

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 28 29

Sin comentarios

Microsens Media Converter/Signal Repeater Module Manual de usuario Pagina 14