
MICROSENS User Manual Device Server RS-232/422/485 Port to 1x or 2x 10/100TX
and Device Server RS-232/422/485 Port to 1x 100FX
Device Event Notification:
Hardware Reset (Cold Start): Rebooting the device server will trigger the
event
Software Reset (Warm Start): Restarting the computer will trigger the
event
Login Failed: Using wrong password in console will trigger the event
IP Address Changed: Changing network setting will trigger the event
Password Changed: Changing the password will trigger the event
Access IP Blocked: Report blocked IP addresses
Redundant Power Change: Power change will trigger the event
Redundant Ethernet Change: Ethernet master port change will trigger the
event
Port Event Notification:
DCD changed: When DCD (Data Carrier Detect) signal changes, indicating
the modem connection status has changed, the event will be triggered.
DSR changed: When DSR (Data Set Ready) signal changes, indicating that
the data communication equipment is powered off, the event will be
triggered.
RI changed: When RI (Ring Indicator) signal changes, indicating the
incoming of a call, the event will be triggered.
CTS changed: When CTS (Clear To Send) signal changes, indicating that
the transmission between computer and DCE can proceed.
Port connected: In TCP Server Mode, when the device accepts an incoming
TCP connection, this event will be trigger. In TCP Client Mode, when the
device has connected to the remote host, this event will be trigger. In
Virtual COM Mode, when Virtual COM is ready to use, this event will be
trigger.
Port disconnected: In TCP Server/Client Mode, when the device lost the
TCP link, this event will be trigger. In Virtual COM Mode, When Virtual
COM is not available, this event will be trigger.
Select the events and the type of SNMP mail, SNMP Trap or Syslog, click Submit to
enable it.
32
Comentarios a estos manuales