Microsens RS232 Especificaciones descargar pdf (Pagina 21)

4 Port Industrial Device Server Manual page 21/36

MICROSENS GmbH & Co. KG - Küferstraße 16 - 59067 Hamm - Tel. +49 2381/9452 0 - Fax 9452 100 - www.microsens.com

Notification

Specify the events that should be noticed. The events can be noticed by E-mail,

SNMP trap or system log.

The following table describes the labels in this screen.

Label

Description

DCD changed

When DCD (Data Carrier Detect) signal changes, it indicates that the

modem connection status has changed. A Notification will be sent.

DSR changed

When DSR (Data Set Ready) signal changes, it indicates that the data

communication equipment is powered off. A Notification will be sent.

RI changed

When RI (Ring Indicator) signal changes, it indicates that the incoming of

a call. A Notification will be sent.

CTS changed

When CTS (Clear To Send) signal changes, it indicates that the

transmission between computer and DCE can proceed. A notification will

be sent.

Port connected

In TCP Server Mode, when the device accepts an incoming TCP

connection, this event will be trigger. In TCP Client Mode, when the device

has connected to the remote host, this event will be trigger. In Virtual

COM Mode, Virtual COM is ready to use. A notification will be sent.

Port

disconnected

In TCP Server/Client Mode, when the device lost the TCP link, this event

will be trigger. In Virtual COM Mode, When Virtual COM is not available,

this event will be trigger. A notification will be sent.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 35 36

Sin comentarios

Microsens RS232 Especificaciones Pagina 21