Microsens 10/100Base-TX to 100Base-FX Manual de usuario descargar pdf (Pagina 5)

Bridge Module 10/100Base-TX/100Base-FX Page 5/7

MICROSENS GmbH & Co. KG - Küferstr. 16 - D-59067 Hamm - Tel. +49 (0)2381/9452-0 - Fax -100 - www.microsens.com

To access the data of the modules via SNMP it is necessary to integrate the structure of

the MIB into the existing network management. The MICROSENENS MIB file can be

downloaded from the web based management of module. The MIB file is in ASCII

format.

The configuration of the network management is protected by a password. The

following values are default from the factory.

Console: Read only Console: Admin WEB: Configuration

Username user Admin

Password microsens Microsens microsens

The password for the web based configuration is the same as the administrator

password of the console and can be changed together with it.

Configuration

The configuration of the ports is done manually by either the management (DIP-switch

10: on) or alternative by the DIP-switches (DIP-switch 10: off). As factory default the

configuration by management is activated, to allow an immediate access to the

configuration.

DIP-switch Function (ON/OFF)

1 ALM for fiber port

2 Link Through from TP port to fiber port

3 Link Through from fiber port to TP port

4 ON: Full duplex for fiber OFF: Half duplex for fiber

5 ON: Autonegotiation for TP OFF: 100Mbps, full duplex for TP

6 Flow Control

7 – 9 Bandwidth limitation

10 ON: Conf. by Management OFF: Conf. by DIP-switches

11 Reserved

12 Reserved

The factory default settings are:

DIP-switch Function (ON/OFF)

1 Off

2 Off

3 Off

4 ON: Full duplex for fiber

5 ON: Autonegotiation for TP (10/100Base-TX)

6 Off

1 2 3 4 5 6 7

Sin comentarios

Microsens 10/100Base-TX to 100Base-FX Manual de usuario Pagina 5